Walls are coming down!

Walls of the 2 bedrooms are coming down, preparing the area for expansion.





A date on the back of a sheet of drywall tells of the time when I put these walls up.  My how time flies!



Next comes demo'ing part of the existing layout.  Emptied the staging yards and moved as much over to the remaining sections as possible.

Cerro Vista and Warm Springs are definitely looking like storage yards now!




Pic of the last train run on GNW Phase 2, moving off to storage.


More to come as work progresses!

Comments

Post a Comment

Popular posts from this blog

Let’s Configure a Node – The Beauty of LCC (With a bonus section on connecting LCC to PanelPro)

Image
Recall one of the drivers for trying out LCC was to avoid writing detailed code.   Yes, I ~can~ write code.   But it is not my interest or hobby.   As such, anything that can help me translate what is in my head to implementation on a chip somewhere with as little brain damage as possible is quite welcome in my book.   Additionally I did not want the brains of the layout to live in a PC.   There are days when I just want to come down to the basement, flip on the power switch, and run trains.   And… if I am going to go through the trouble of having signals, I want them to come up and operating properly immediately.   Yea, I know I can set up a PC to boot up, execute the right programs and get running on its own.   Sorta.   It’s just one more piece of equipment and step I just don’t care to deal with.        Anyway…. So a big part of my hesitation of leaping into LCC was the angst associated with programming ...
Read more

Configuring Push-buttons for Turnout Control in LCC (with BONUS section on Adapting JMRI for Feedback)

Image
So ALL the efforts, costs, brain damage and such to get LCC integrated into the layout is paying off in this one new step.  Let me explain. With LCC, each node is essentially its very own stand-alone microprocessor, capable of processing commands INDEPENDENTLY of a central PC or other server.  It just is connected to at the CAN bus, either looking for commands to respond (consumer) to or to issue them (producer).  SO... this addresses one of the goals of integrating LCC into my layout.  Sometimes I like to come down into the layout room and just run trains.  I don't have others with me, and for me, its a great way to unwind.  When I do that, I don't want to have to futz with turning on a PC and getting it going.  Ya, I know, some say it is not that big of a deal.  But if I am only going to be there for 5 or 15 minutes, seems like a hassle to mess with that.  I just want to through the power switch on, have the layout come to life, and run s...
Read more

LCC and Wiring Continues

Image
Slower than desired, but better to do it right now than try to fiddle it in later.... In my last staging yard, I never did install feeders.  Instead I just counted on the continuity of the turnouts to carry power to each of the 16 staging tracks.  Bad idea.  ~Most~ stayed powered up over the 10 or so years it operated.  ~Some~ randomly dropped out... necessitating fishing and soldering wires onto tracks with 7" spacing between decks.  Not uber-fun at all. SO... with GNW Phase 3, I promised myself ALL track would have feeders every 6' (one feeder per 2 sticks of flex), plus additional feeders in any other complex areas such as yard throats.  This would also allow me to have every other stick of flex not have to be soldered at the track jointers, allowing for expansion and contraction of the benchwork.  BUT... this comes at a cost.  Instead of 16 single ended tracks, I elected to have a 9-track staging yard, each track capable of holding 3 tra...
Read more